Humax CI-5100X - Manual (Page 7)

STB Connections
STANDBY LED(RED)
Indicates that the STB is under standby.
TV LED(AMBER)
The LED lights on in TV mode.
RADIO LED(GREEN)
The LED lights on in RADIO mode.
STANDBY
Press to switch between Operation and
Standby modes.
TV/RADIO
Press to switch between TV and Radio modes.
P-
Use to change services down.
P+
Use to change services up.
SLOT
For a two CA Module with a smart card.
Front & Rear Panel
1 5
6
7
8
2
3
4
LNB IN
Use to connect an antenna.
LNB OUT
Use it when connecting to another STB.
RS-232C
Use it when connecting to your PC.
TV SCART
For the audio/video input of the TV.
VCR SCART
For the VCR.
AUDIO/VIDEO OUTPUT
Audio/video signal from your STB to VCR
or TV.
0/12V OUT
For an external LNB switch.
RF OUTPUT
Use to connect a RF signal from your STB to
RF(ANT) input jack on your TV.
RF INPUT
Use to connect a general Aerial Antenna and
CABLE jacks to a RF input jack on the STB.
S/PDIF
Output for connection to a digital amplifier.
1 6
7
8
9
10
2
3
4
5
E6