Harbor Freight Tools 92403 - Manual (Page 4)

Page 4 SKU 92403 for technical questions, please call 1-800-444-3353
Unpacking
When unpacking, check to make sure the parts listed on page 8 are included. If any parts
are missing or broken, please call Harbor Freight Tools at the number on the cover of this
manual as soon as possible.
21. spray painting only. Never use this unit with gasoline, kerosene, or any other
flammable solvent.
22. drain Air Compressor filter daily. Do not allow air moisture to build up inside the
compressor.
23. Make sure all equipment is rated to the appropriate capacity. Make sure the
regulator (not included) is set to at least 10 PSI lower than the lowest rated piece of
equipment you are using.
warning: the warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. it must be under-
stood by the operator that common sense and caution are factors which cannot be built
into this product, but must be supplied by the operator.
wARning: The brass components of this product contain lead, a chemical known to the
State of California to cause birth defects (or other reproductive harm).
(California Health & Safety Code § 25249.5, et seq.)
wARning: Some dust created by power sanding, sawing, grinding, drilling, and other con-
struction activities, contains chemicals known [to the State of California] to cause cancer,
birth defects or other reproductive harm. Some examples of these chemicals are:
-
Lead from lead-based paints
- Crystalline silica from bricks and cement or other masonry products
- Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To
reduce your exposure to these chemicals: work in a well ventilated area, and work with ap-
proved safety equipment, such as those dust masks that are specially designed to filter out
microscopic particles.
(California Health & Safety Code § 25249.5, et seq.)
Note : Performance of the compressor (if powered by line voltage) may vary depending
on variations in local line voltage. extension cord usage may also affect tool perfor-
mance.