beautypg.com

Before using – haier XQB55-10H User Manual

Page 7

background image

5

1.

The height of the drain hose shall be

less than 10cm, or the drainage will not
be smooth, and cost such long time that
the machine may stop at mid way.

2.

Do not trample or press the drain hose.

3.

If the drain hose is too long, cut it at mid

point. To make smooth drainage, cut the
front end of the hose slantingly.

4.

If extra drain hose is needed, please

make separate purchase. The inner
diameter of the extra hose shall not
less than 30mm, and the length shall
not exceed 1.5m.

If the extra hose is too long, cut it
either at A or at B point.

How to change the direction of the drain hose

Usage of the dr ain hose

The drain hose shall drain smoothly

Before Using

Before Using

1.

Loosen the fastening screw of the

back cover to take off the back cover.
Be careful not to do it by force to
prevent breaking the claw of the back
cover.(as indicated in Figure 1)

3.

Extend the drain hose from the installation

hole at the right side of the base frame. Fix
the drain hose onto the base frame with the
drain hose frame and fasten the screw. Then
set the drain hose hook on the drain hose and
hang the drain hose on the hanging hole of
the cabinet. (As
indicated in Figure 3)

4.

To install the back cover, first hang the lower

beard of the back cover on the cabinet, then
push the claws at the two side and the upper
end from bottom to top to resume the original
setting. Be careful not to do
it by force. Then fasten
the screw (two points)
(as indicated in Figure 4).

2.

Take off the drain hose from the cabinet.

Nip the drain hose outlet slightly.
Dismantle the drain hosehook. Loosen
the fixing screw of the drain hose frame
to dismantle the drain hose frame. Pull
the drain hose into the cabinet from the
left side of the base frame.

Screw

Back cover

Drain hose frame

Nip the drain hose outlet
and take off the drain hose hook

Screw

Top claw

Claws at the
two sides

Lower bread

Figure 3

Figure 1

Figure 4

Figure 2