HONDA GXV50 - Manual (Page 11)

Storage Precautions
Engine Oil
Draining the Fuel Tank and Carburetor
Engine Cylinder
Removal from Storage
TRANSPORTING
ENGLISH
DRAIN BOLT
GASKET
CARBURETOR
Align the rib on the flywheel with
the notch on the fan cover.
11
If your engine will be stored with gasoline in the fuel tank and
carburetor, it is important to reduce the hazard of gasoline vapor
ignition. Select a well-ventilated storage area away from any
appliance that operates with a flame, such as a furnace, water
heater, or clothes dryer. Also avoid any area with a spark-
producing electric motor, or where power tools are operated.
If possible, avoid storage areas with high humidity, because that
promotes rust and corrosion.
Keep the engine level in storage. Tilting can cause fuel or oil
leakage.
With the engine and exhaust system cool, cover the engine to
keep out dust. A hot engine and exhaust system can ignite or melt
some materials. Do not use sheet plastic as a dust cover. A
nonporous cover will trap moisture around the engine, promoting
rust and corrosion.
Gasoline is highly flammable and explosive, and you
can be burned or seriously injured when handling
fuel.
Stop engine and keep heat, sparks, and flame away.
Wipe up spills immediately.
Place an approved gasoline container below the carburetor, and
use a funnel to avoid spilling fuel.
Handle fuel only outdoors.
Reinstall the spark plug.
Pour a tablespoon 5 10 cm (5 10 cc) of clean engine oil into
the cylinder.
Remove the spark plug (see page ).
Change the engine oil (see page ).
After all fuel has drained into the container, reinstall the
carburetor drain bolt and gasket. Tighten the carburetor drain
bolt securely.
Pull the starter grip slowly until resistance is felt and the notch
on the starter pulley aligns with the hole at the top of the recoil
starter cover. This will close the valves so moisture cannot enter
the engine cylinder. Return the starter grip gently.
Check your engine as described in the BEFORE OPERATION
CHECKS section of this manual (see page ).
If the fuel was drained during storage preparation, fill the tank with
fresh gasoline. If you keep a container of gasoline for refueling, be
sure it contains only fresh gasoline. Gasoline oxidizes and
deteriorates over time, causing hard starting.
If the cylinder was coated with oil during storage preparation, the
engine will smoke briefly at startup. This is normal.
If the engine has been running, allow it to cool for at least 15
minutes before loading the engine-powered equipment on the
transport vehicle. A hot engine and exhaust system can burn you
and can ignite some materials.
Keep the engine level when transporting to reduce the possibility
of fuel leakage. Turn the fuel valve lever to the OFF position. Close
the fuel tank vent by turning vent knob clockwise.
Remove the carburetor drain bolt and gasket, then turn the fuel
valve lever to the ON position.
Pull the starter grip several times to distribute the oil in the
cylinder.
2.
1.
3.
1.
2.
3.
4.
5.
8
9
3
05/05/07 11:05:19 32Z4D600_011