Harbor Freight Tools 90416 User Manual

Page 4

SKU 90416 PAGE 4

Feed the Strap (#2) through the slot in the Rachet (#3), and then through the

center of the Rachet Barrel.

See Figure 2.

Pull the end of the Strap (#2) to take up the slack. Tighten the flooring panels

together by lowering the Handle (A) gently. Caution: Be sure you do not

overtighten. The flooring panels must remain flat at all times.

See Figure 3.

Slot in

Ratchet

Center of Ratchet Barrel

#2 Strap

(A) Handle

Figure 2

To release the Ratchet tension, raise the Handle (A), pull each of the Spring

Plates (B) back from the Ratchet center so the Handle locks fully open. Pull the

Strap (#2) out of the Ratchet in the opposite direction that it was fed into the slot

of the Ratchet.

See Figure 4.

Repeat ratcheting until all flooring is laid, every three boards or as manufacturer

has instructed.

Roll up Strap (#2) for storage.

Figure 4

(A) Han-

dle

#2 Strap

(B)

Spring

Plates

Figure 3

#2 Strap

Caution: Be careful not to pinch fingers in moving parts.