Hotpoint RSR50V - Manual (Page 6)

Getting your Appliance ready for use.
6
Before connecting to the mains electricity
supply leave the appliance to stand for 2
hours to allow the cooling system to settle.
Clean the appliance, and be thorough,
especially in the interior. (see ’Caring for
your Appliance’ - Cleaning, page 11).
FFiin na all C Ch heecckk::
Before you start using your appliance check
that:
- The appliance is level.
- It is thoroughly dry inside.
- There is adequate air circulation.
- Accessories are correctly placed in their
positions.
SStta arrttiin ng g::
Insert the plug into the wall socket and
switch on the electricity supply. When you
open the refrigerator door, the light will
come on.
There is a control dial situated on the right
handside of the refrigerator interior.
Turning the dial, clockwise from SSTTO OPP ((0 0))
to a higher setting will start the appliance
working.
You will hear a noise as the compressor
starts up.
RRu un nn niin ng g iin n tth hee C Co om mp prreesssso orr::
Your appliance is operated by a compressor
which switches on and off in order to
maintain the internal temperature.
The compressor requires a running in peri-
od of up to 2 months. During this time it
has to work a little harder and may result in
more noise than usual.
Noise levels are also determined as to the
location of the appliance, what is stored
and where the items are placed,
W Wh heetth heerr tth hee cco om mp prreesssso orr iiss rru un nn niin ng g
o orr n no ott,, iitt iiss n no orrm ma all tto o h heea arr sso ou un nd dss
ccrreea atteed d b byy tth hee lliiq qu uiid d a an nd d g ga asseess sseea alleed d
w wiitth hiin n tth hee ssyysstteem m..
627494en.qxd 24.9.2003 11:51 Page 6