Homelite UT44170 - Manual (Page 4)

Page
SPECIFIC SAFETy RULES
 Use non-slip, heavy-duty protective gloves when operating
the grass shear/shrubber and when installing or removing
blades.
 Replace any blade or other parts that are cracked or
damaged. Always make sure blade is installed correctly
and securely fastened before each use. Failure to do
so can cause serious personal injury to the operator,
bystanders, or damage to the unit.
 Never cut any material over 3/8 in. diameter.
 Maintain a firm grip on handle while cutting with a blade.
Keep the blade away from body.
 Know how to stop the unit quickly in an emergency.
 Keep both hands on handles when the extension handle
is connected to the unit and the unit is in use.
 Check damaged parts. Before further use of the grass shear/
shrubber, a guard or other part that is damaged should be
carefully checked to determine that it will operate properly
and perform its intended function. Check for alignment of
moving parts, binding of moving parts, breakage of parts,
mounting, and any other condition that may affect its
operation. A guard or other part that is damaged should
be properly repaired or replaced by an authorized service
center unless indicated elsewhere in this manual.
 Install the padlock (not include d) into the switch before
making any adjustments, changing accessories, or storing
the grass shear/shrubber. Such preventive safety measures
reduce the risk of starting the product accidentally.
 Service on the product must be performed by qualified
repair personnel only. Service or maintenance performed
by unqualified personnel could result in injury to the user
or damage to the product.
 Always stop motor, padlock (not included) switch when
not in use, before attempting to remove any obstruction
caught or jammed in the blade, before removing, installing,
or making any blade adjustments.
 Battery powered units do not have to be plugged into an outlet;
therefore, they are always in operating condition. Be aware
of possible hazards even when the unit is not operating.
 NEVER attempt to change the cutting attachments without
first padlocking (not included) the switch or installing the
lockout pin into the switch.
 Never use grass shear/shrubber if the switch will not turn
the unit on or off. A unit that cannot be controlled by the
switch is dangerous and must be repaired before use.
 Grass shear/shrubber is for cutting grass, hedges, and
light weeds only. Do not use for any other purpose.
 Maintain grass shear/shrubber with care. Keep cutting
edge sharp and clean for best performance and to reduce
the risk of injury. Follow instructions for lubricating and
changing accessories. Keep handles dry, clean, and free
from oil and grease.
 Know your power tool. Read operator’s manual carefully.
Learn its applications and limitations, as well as the
specific potential hazards related to this power tool.
Following this rule will reduce the risk of electric shock,
fire, or serious injury.
 Battery tools do not have to be plugged into an electrical
outlet; therefore, they are always in operating condition. Be
aware of possible hazards when not using your battery tool
or when changing accessories. Following this rule will reduce
the risk of electric shock, fire, or serious personal injury.
 Do not place battery tools or their batteries near fire or heat.
This will reduce the risk of explosion and possibly injury.
 Do not crush, drop or damage battery pack. Do not
use a battery pack or charger that has been dropped or
received a sharp blow. A damaged battery is subject to
explosion. Properly dispose of a dropped or damaged
battery immediately.
 Batteries vent hydrogen gas and can explode in the
presence of a source of ignition, such as a pilot light.
To reduce the risk of serious personal injury, never use
any cordless product in the presence of open flame. An
exploded battery can propel debris and chemicals. If
exposed, flush with water immediately.
 For best results, your battery tool should be charged in
a location where the temperature is more than 50°F but
less than 100°F. To reduce the risk of serious personal
injury, do not store outside or in vehicles.
 Save these instructions. Refer to them frequently and use
them to instruct others who may use this tool. If you loan
someone this tool, loan them these instructions also to
prevent misuse of the product and possible injury.
 Recharge only with the charger specified by the
manufacturer. A charger that is suitable for one type of
battery pack may create a risk of fire when used with
another battery pack.
 Under abusive conditions, liquid may leak from the battery,
avoid contact. If contact accidentally occurs, flush with water.
If liquid contacts eyes, additionally seek medical help. Liquid
leaking from the battery may cause irritation or burns.
 When servicing a power tool, use only identical
replacement parts. Follow instructions in the Maintenance
section of this manual. Use of unauthorized parts or failure
to follow Maintenance instructions may create a risk of
shock or injury.
IMPORTANT SAFETy INSTRUCTIONS
 Do not dispose of batteries in a fire. The cells may
explode. Batteries should be recycled. Consult your
local waste authority for information regarding available
recycling and/or disposal options.
 When replacing batteries, all batteries should be replaced
at the same time. Mixing fresh batteries and discharged
batteries could increase internal cell pressure and rupture
the discharged batteries.
 When replacing batteries into this product, observe
proper polarity. Reversing polarity can result in leakage
or explosion.
 Save these instructions.