haier HW-DS50TVE - Manual (Page 23)

Front Load Washing Machine Model:HW-DS50TVE SERIES
20
Failure:no water inletting
Troubleshooting:
（ See fig 2）
Failure:no draining
Troubleshooting:
N
Check if power plug exists 220V-240V AC
voltage at the import pin
Is the tap shut off or the water pressure
too low?
Y
Open tap or wait for normal water pressure
N
Check if water is leaking from washer
connection, especially between inlet pipe
and tap. to make sure of no bends.
Reconnect inlet pipe.
N
Check if filter of electromagnetic valve is
jammed
Clean filter
Choose pre-wash program and start ，
then check if there is 220-240V at export
pin of electromagnetic valve
Y
Cut off power and check if plugs are connected
well by pulling the plug of PCB.
Insert the plug well and test
Y
Y
N Replace PCB
Y
Choose pre-wash program and start ，
Check if there is 220-240V at import pin
of electromagnetic valve
Is there open circuit between
electromagnetic valve and PCB?
Y
Replace electromagnetic valve
N
Reconnect the wire
Y
N
N
Replace PCB
Adjust the height of drain pipe to
80-100 cm
Is the height of drain pipe too high?
Y
N
Turn filter anticlockwise，open and check if
filter is jammed Y
Clean and tighten filter clockwise.
N