haier AS072XHERA - Manual (Page 18)

16
A
Operation
Timer on/off operation
Remote control unit
TIMER operation
Set Clock correctly before starting Timer operation (refer to page 2)
You can let unit start or stop automatically at following times: Before you wake up in the morning, or get
back from outside or after you fall asleep at night.
TIMER ON/OFF
(1) After unit start, select your desired operation mode.
Operation mode will be displayed on LCD.
(2) TIMER mode selection
Press TIMER button to change TIMER mode.
Every time the button is pressed, display changes as follows:
Remote
controller
Select your desired TIMER mide (TIMER ON or TIMEROFF) ON or OFF
will flash.
(3) Timer setting
Press HOUR / button.
Every time the button is pressed, time increases 1 min, If button is kept
pressed, time will change quickly.
Every time the button is pressed, time decreases 1 min, If button is kept
pressed, time will change quickly. Time will be shown on LCD. It can be
adjusted within 24 hours.
(4) Confirming your setting
After setting correct time, press SET button to confirm, " "
or " " stops flashing.
Time displayed: Unit starts or stops at x hour x min (TIMER
ON or TIMER OFF)
Timer mode indicator on indoor unit lights up.
To cancel TIMER mode
Just press TIMER button several times until TIMER mode disappears.
Hints
After replacing batteries or a power failure happens, Time setting should be reset.
Remote controller possesses memory function when use TIMER mode next time, just Press SET button
after mode selecting if timer setting is the same as previous one.
ON ON OFF OFF
TIMER ON TIMER OFF TIMER ON-OFF
AM 12:00
PM
12:00
PM
12:00 AM 12:00
BLANK
ON
OFF
ON
OFF
TEMP
HEALTH FAN
MODE
SLEEP SWING
CLOCK
TIMER
SET
LOCK LIGHT RESET
STERILIZE
HEALTH AIRFLOW
FRESH
CODE