HONDA HRR216TDA - Manual (Page 28)

OPERATION
26
Dry Grass
If the ground is too dry, mowing will stir up a lot of dust. Besides being
unpleasant to work in, too much dust will clog the air filter. If dust is a
problem, water your lawn the day before mowing. Mow when the grass
is dry to your touch, but the soil is still moist.
Wet Grass
Wet grass is slippery and can make you lose your footing. Also, wet
grass clippings will clog the mower deck and collect in clumps on the
lawn. Always wait for wet grass to dry before mowing.
Fallen Leaves
When equipped with the grass bag (optional for HRS models), your
mower can be used to pick up fallen leaves for disposal. If using the
mower to bag large amounts of fallen leaves, and not for mowing, set
the cutting height adjustment levers so the front of the mower deck is
one or two settings higher than the rear.
If you want to mulch fallen leaves into your lawn, don’t let the leaf cover
get too deep before you begin. For best results, start mulching while
grass still shows through the leaf cover. In places where fallen leaves
completely cover the grass, remove the leaves by raking, or install a
grass bag, so your mower can pick them up for disposal.
Clogged Mower Deck
Before clearing a clogged mower deck, stop the engine and turn the
fuel valve to the OFF position. With the spark plug cap disconnected,
tilt the mower so the carburetor side is up.
Clear a clogged deck with a stick, not your hands.