haier XQB70-10 - Manual (Page 16)

After switching on, the washing machine reserved wash program will be automatically set
inactive. If you desire a wash cycle to end at a reserved time, you can press the
" Reservation "
button to set a reserved wash program. Refer to " The button of Reservation " on page 11.
When " Reservation " becomes active, the nixie tube
displays the time to the end of the reserved wash cycle, and
the indicator turns on.
To change the running program or cancel the reservation,
you should cut off the supply and reselect.
the washing will finish
about 18 hours later
Time list of each program (minute)
Total time: including the normal water inlet time, drain time, excluding the power off time. The
total washing time may be influenced by the water inlet pressure and water level.
Spin time: the time from intermittent running to finishing.
The Standard or Jeans program could combine the process of soak during which the washing
machine firstly soak for about 15~45 min after water filling and then begins to wash.
When "Quick wash" program is chosen, the washing machine would automatically set water
level and full processes of wash, rinse and spin.
Confirm the reserve program
Reserve
Start
Pause
Standard
Program
Gentle
Jeans
Quick
Water
level
Wash
(min)
About 6 About 35~47
About 5.5~6.5 About 35~48
About 10
About 24
1~10
1~10
About 3 About 4
About 3
About 2
About 2
Rinse
(min) Spin
(min)
Total time(min)
Rinse once, about 4
Rinse twice, about 4
Rinse twice, each abut 4
Rinse twice,each about 4
Using process Using process
6 Press the "start/pause" button
5 Push the "Reservation" button to select
suitable reserve program
1~10
5 Close the top lid
6 Finish washing
Except water filling and draining, if the
top cover is opened, the washing
machine will stop running and alarm.
After Finishing wash
alarm automatically
The washing machine cuts off the power supply
automatically when wash cycle ends.