Hunter Fan HEPATECH 30027 - Manual (Page 2)

2 ©2011 Hunter Fan Company 41669-01 20110126
1. This Air Purifier is designed for use on a flat,
level surface and may not work properly on
an uneven surface. ALWAYS place this Air
Purifier on a firm, level surface. ALWAYS
place the Air Purifier at least six (6) inches
away from walls and three (3) feet from heat
sources such as stoves, radiators, or heaters.
2. Place the Air Purifier in an area that is out of
the reach of children.
3. Before using the Air Purifier, extend the cord
and inspect for any signs of damage. DO
NOT use the product if the cord has been
damaged.
4. To reduce the risk of electric shock, this
product has a polarized plug (one blade is
wider than the other) as a safety feature.
This plug will fit into a polarized outlet only
one way. If the plug does not fit fully into the
outlet, reverse the plug. If it still does not
fit, contact a qualified electrician. DO NOT
attempt to defeat or override this safety
feature.
5. ALWAYS UNPLUG the Air Purifier when it
is not in operation, while the filter is being
changed, and while it is being cleaned.
6. DO NOT tilt or move the Air Purifier while it
is in operation. Shut off and unplug before
moving.
7. DO NOT immerse the Air Purifier in water
as permanent damage will occur. Refer to
and follow the CLEANING AND FILTER
REPLACEMENT instructions.
8. DO NOT run the ionizer if tobacco smoke, air
fresheners, dripless wax candles, or grease
from cooking is present.
Thank you for purchasing the HEPAtech™ Air
Purification System from Hunter Fan Company.
You have purchased our latest development in
portable Air Purification Systems. This system
has been developed to improve the quality of
the air you breathe.
Our HEPAtech™ Air Purification System out
performs other air purification systems by
SAFETY INSTRUCTIONS
Save These Important Instructions
1. Take the air purifier out of the box and remove
the clear plastic protective bag. Place the unit
on a firm level surface.
2. Before turning the Air Purifier “on”, You
need to open the front cover and remove
the protective plastic that is surrounding the
HEPAtech™ system filter. Press the buttons
that are on each side of the front grill (See
Figure 1). When they are pressed inward,
you will be able to pull the front grill forward,
opening the unit.
3. The filter comes to you installed in the correct
position. Grasp the filter, and pull it forward,
up, and out of the unit. Remove the plastic
wrapping and replace the filter in the unit.
The white HEPAtech™ filter material should
be facing outward (towards you).
4. Before closing the front cover, check the
placement of the pre-filter. It is installed under
clips in the front cover. The pre-filter should
be replaced every three months.
5. Close the front cover by once again pressing
the buttons and allowing the front cover to
slip into place over the buttons. The unit is
now ready for normal operation.
6. Plug the unit into a 120V electrical outlet.
INSTRUCTIONS
quickly and effectively removing dust, smoke,
and pollen particles as small as .3 microns in
size. Room air is pulled in through the front grill
where larger particles and odors are caught on
the pre-filter. Smaller particles passing through
the pre-filter are caught on the main filter. The
ionizer helps remove the remaining particles
before being pushed back into the room through
the top vent.
USINg YOUR AIR PURIFIER