Healthrider HRTL89406.0 - Manual (Page 9)

9
6. Attach the console assembly to the Uprights (85)
with four Console Bolts (72) and four 3/8” Star
Washers (71) (only one side is shown).
Start all
four Console Bolts before tightening any of
them.
71
72
85
Console
Assembly
6
7. Note the location of the 75 ohm antenna terminal
on the treadmill. For the television to operate
properly, an antenna, a CATV cable, or a VCR
must be connected to the 75 ohm antenna termi-
nal (see page 10).
7
8. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key
in a secure place; the hex key is used to adjust the walking belt (see page 27).
To protect the floor or carpet
from damage, place a mat under the treadmill.
5. Remove the band securing the TV Cable (63) to
the left Upright (85). Connect the TV Cable to the
cable extending from the console assembly.
Then, insert the TV Cable into the left Upright.
Next, insert the brackets on the Handrails (70) into
the left Upright (85) and the right Upright (not
shown).
Make sure that no wires are pinched.
63
70
Bracket
85
Console
Assembly
5
75 Ohm
Antenna
Terminal