Washing sequence using process using process, Wash, Figure 1 figure 2 figure 4 – haier WMS656 User Manual
Page 11: Figure 3
Washing sequence
Using process
Using process
Wash
DRAIN
STRONG
STANDARD
Spin timer
SPIN TIMER
Wash timer
WASH TIMER
WASH SELECTOR
Wash selector
(To set to below 2 minute,
first set to 5 minute then
turn it back. it can increase
the service life of the timer).
(Strong current,
standard current)
(to set to below 1 minute,
first set to 2 minute then
turn it back. it can increase
the service life of the timer).
Spin water-filling entrance
Figure 1
Figure 2
Figure 4
Wash
DRAIN
STRONG
WASH SELECTOR
WASH SELECTOR
1. Fill the water and add the dissolved washing
powder to make the water level reach the preset
position. (Figure 1)
Run washing program for some time to stir and
dissolve the powder completely.
2.Put in the laundries. If the water quantity is
insufficient, please add water.
3.Select the current.
Select the strength of the current according to
the laundries. (Figure 2)
4.Select the washing time
Select the washing time according to the laundries.
(Figure 2)
5.After washing, set the "WASH SELECTOR" at
"DRAIN". (Figure 4).
STANDARD
STANDARD
STRONG
DRAIN
OFF
9
OFF
3
3
Spin water-filling entrance
Figure 3
WASH TIMER
OFF