Henny Penny OFE- 290 - Manual (Page 3)

Model OFE- 290
3-4. SWITCHES AND Refer to image at end of this section.
INDICATORS
Product Selection Buttons Select the number of heads, or product, to be cooked by pressing
the button below the menued item; shortening will then heat to
drop temperature of that item
Pressing the same button again begins the Cook Cycle; the display
changes from “DROP” to counting down the cook time in minutes
and seconds
At the end of the Cook Cycle, the alarm sounds and the display
reads “DONE”; press the cycle button that is flashing, to stop the
alarm ; the fryer then resets to the Cool Mode
A Cook Cycle can be aborted at any time by pressing and
holding the product button.
Time/Temperature Display A four digit LED type display which shows the remaining cook time
during Cook Cycles and also the shortening temperature on
demand from the operator
Heat Indicator Illuminates whenever the control calls for heat; when shortening
temperature has been reached, the heat light goes off
HI Temperature Indicator The display reads “HI” if the shortening temperature is 40° F above
the setpoint
Drop Indicator The display reads “DROP” when the shortening has reached
the setpoint temperature (will read “DROP” 2° before setpoint and
4° above setpoint )
Done Indicator The display reads “DONE” at the end of the Cook Cycle
Temperature Button Press this button to read the temperature of the shortening during a
Cook Cycle
SCAN Button Pressing this button toggles through the items being programmed
FUNCTION Button Used in the programming of the controls
EXIT FILL Button After filtering the fryer, if in the filter lockout mode, the display reads
“FILL”, and the EXIT FILL button must be pressed.
504 3-3