Harbor Freight Tools 93629 - Manual (Page 3)

8. dress properly. Do not wear loose clothing or jewelry as they can be caught in
moving parts. Protective, electrically non-conductive clothes and non-skid foot-
wear are recommended when working. Wear restrictive hair covering to contain
long hair.
9. do not overreach. Keep proper footing and balance at all times. Do not reach
over or across running tools or air hoses.
10. disconnect air hose and release any built-up air pressure. Never service the
Air Sander or disassemble with the air hose attached. Always release any
built-up air even after disconnecting hose. Disconnect the Air Sander when
not in use.
SKU 93629 For technical questions, please call 1-800-444-3353 PAGE 3
6. store idle equipment. When not in use, tools must be stored in a dry location
to inhibit rust. Always lock up tools and keep out of reach of children.
7. use the right tool for the job. Do not attempt to force a small tool or
attachment to do the work of a larger industrial tool. There are certain
applications for which this tool was designed. It will do the job better and more
safely at the rate for which it was intended. Do not modify this tool, and do not
use this tool for a purpose for which it was not intended.
4. observe work area conditions. Keep work area well lit. Do not use pneumatic
tools in the presence of flammable gases or liquids.
5. Keep children away. Children must never be allowed in the work area. Do not
let them handle machines, tools, extension cords, or air hoses.
11. remove adjusting wrenches. Check that adjusting wrenches are removed
from the tool and work surface before attaching to an air source.
12. avoid unintential starting. Be sure the Throttle (2) is in the oFF position
when not in use and before plugging in. Do not carry any tool with your finger on
Throttle, whether it is attached to an air source or not.
13. stay alert. Watch what you are doing. Use common sense. Do not operate any
tool when you are tired.
14. Do not operate tool if under the influence of alcohol or drugs. Read warning
labels if taking prescription medicine to determine if your judgement or reflexes
are impaired while taking drugs. If there is any doubt, do not operate the tool.
15. compressed air only. Use clean, dry, regulated, compressed air at 90 psi.
Never use oxygen, carbon dioxide, combustible gases, or any other bottled gas
as a power source for this tool.