Hunter Fan CARE FREE 33202 - Manual (Page 4)

41553-01 06/04/2004 4 © 2004 Hunter Fan Company
Figure 2
Power Light or NiteGlo™
Night Light Control
Power/Speed
Control
Power Light (Some Models): The light will be
illuminated when the power is on.
Fan Power/Speed Control: Tur ns the
humidifier ‘ON’ and ‘OFF’. The power should
always be off before unplugging the humidifier,
moving the humidifier, or refilling the water
tank.
NiteGlo™ Night Light Control (Some
Models): Turns the night light ‘ON’ and ‘OFF’.
The night light can be turned on even if the
humidifier fan is turned off.
Humidifier Features
Using Your Humidifier
1. Remove The Care Free ® Humidifier Plus
Evaporative Humidifier from its packaging.
Read and Save the Instructions.
2. Place the humidifier on a hard, flat, water
resistant surface. Always place the humidi-
fier at least six (6) inches away from walls
and sources of heat.
3. Lift the main housing to confirm that the
PermaWick™ filters are placed upright in
the slots. Replace the main housing. (See
Figure 1.)
4. Remove the water tank and take it to the
sink or tub to fill.
5. Turn the tank upside down and unscrew
the tank cap by turning it counterclockwise.
Fill the water tank with cool water and re-
place the tank cap (Never use hot water).
Be sure not to overfill the tank as water
damage may occur to furniture or flooring
due to spillage.
HUNTER WILL NOT ACCEPT RESPONSIBIL-
ITY FOR DAMAGE TO PROPERTY CAUSED
BY WATER SPILLAGE.
6. Carry the tank back to the humidifier. Turn
the tank upright and place it on the hu-
midifier. Be sure that the tank is seated
properly in the base. If the tank is properly
located on the base, you will see air bubbles
flowing up into the tank.
7. With the power control knob in the ‘OFF’
position, plug the humidifier into the wall.
CAUTION: Never plug in the Humidifier
while your hands are wet as Electric
Shock could occur.
Place the full tank on the unit and allow
the water to fill the bottom tray. The water
is at the proper level in the bottom tray
when the tanks stops bubbling. Run the
unit on “HI” speed for 1
1 ⁄
2
minutes for
optimum pump operation. Set the unit to
the desired speed.
8. Use the power control knob to turn the
humidifier ‘ON’ by selecting a speed set-
ting.
Only for models with a NiteGlo™ night light
9. Use the control to turn the night light off
and on. The night light can be operated
even if the humidifier fan is turned ‘OFF’.
41553_REV 6-4-04.pmd 6/4/04, 1:36 PM 4