Husqvarna HUV4210-G - Manual (Page 44)

Battery – Gasoline Vehicles
Page 42 2007 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual
ý DANGER
- External: Flush with water. Call a physician immediately.
- Internal: Drink large quantities of milk or water followed with milk of magnesia or vegetable
oil. Call a physician immediately.
- Eyes: Flush with water for 15 minutes. Call a physician immediately.
ý WARNING
• Do not jump start a dead battery using another battery and jumper cables.
The battery in the Husqvarna gasoline vehicle is a 12-volt, low maintenance battery that requires infrequent
watering (Figure 25).
Any corrosion around the positive (+) or negative (–) terminals should be washed off with a solution of baking
soda and water (1 cup (237 mL) per gallon (3.8 L) of water). Rinse solution off the battery. Do not allow this
solution to enter battery. Be sure terminals are tight (battery terminals should be tightened to 12 ft-lb (16
N·m)). Let the terminals dry and then spray them with Battery Terminal Protector Spray (Husqvarna 603 00
00-03). See preceding WARNING and following CAUTION.
ý WARNING
• If battery wire terminals are damaged or corroded, they should be replaced or cleaned as
necessary. Failure to do so may cause them to overheat during operation and could result in
fire, property damage, or personal injury.
Be sure battery clamp is properly tightened. Tighten to 12 ft-Ib (16 N·m). A loose battery clamp may allow the
battery to become damaged from vibration or jarring.
If battery appears weak, have it charged by a trained technician. The battery should never be left discharged
any longer than absolutely necessary (do not leave discharged overnight).
Figure 25 Battery – Gasoline Vehicle Figure 26 Gasoline Battery Electrolyte Level
ELECTROLYTE
LEVEL AT LEAST
1/2 INCH (13 MM)
ABOVE PLATES
OR TO LEVEL
INDICATOR
PLATES
LEVEL
INDICATOR
BATTERY CAP