Electrolux 50435 - Manual (Page 18)

Operating Instructions
18
Running a Wash Cycle
Brief instructions
A wash cycle consists of the following steps:
0 1. Open the door and load the washing.
2. Close the door.
3. Add detergent/conditioner.
4. Set the wash program:
– Set the program using the program selector;
– Set the temperature using the temperature selector;
– Set any program options if required.
5. If necessary, change the spin speed or select RINSE HOLD.
You can alter this setting and the temperature at any time during the
wash.
6. Press the ON/OFF button. Power indicator light comes on.
The washing machine has been switched on. The wash program will
start.
When the wash program has ended:
Important! If the wash cycle ended with a rinse hold, carry out PUMP
OUT or SPIN before opening the door.
3 For safety reasons, the door remains locked for 1-2 minutes after the
end of the program.
7. Open the door and remove the washing.
8. Press the ON/OFF button. The power indicator light will go out.
The washing machine has been switched off.
Loading the washing
3 See "Program Tables" for maximum loads.
For information about the correct preparation of the washing see "Sort
and prepare washing".
0 1. Sort and prepare the washing according to type.
2. Open the door: Pull the handle on the door.
3. Load the washing.
Important! Do not trap washing when closing the door. The fabrics and
the machine could be damaged.
4. Close the door firmly.