Earthquake Sound SuperNova MKV - Manual (Page 8)

The SuperNova MKV subwoofer is hand assembled using high density fiber boards. The cabinet is crafted to exact tolerance for
near nil vibration. The SUPERNOVA's unsurpassed performance stems from:
*600 watts class “D”, high efficiency (99%) power amplifier
*Optical Distortion Limiting circuitry (ODL). A patented process that converts the analog audio signal to
light and optically couple it to the driver stage. When users set the gain too high, the ODL prevents the
amp from clipping; thus limiting distortion to near nil levels
*24 dB / Octave variable filter from 50 Hz to 150 Hz
*Low level inputs/outputs
*High level inputs/outputs
*Auto Signal Sensing
*0-180º Phase Switch
*Volume Control
*Vari-position remote control sensor allows users to position the remote eye anywhere in the room.
MKV’s BA-212 Amplifier
Class “D” Amplifier
U.S. PATENTS:
#6044925, #6460651,
#10/058868, #78/175574,
#78/175565, and other
patents pending.
IN OUT
Sound That Will Move You.
WWW.EARTHQUAKESOUND.COM
LOW LEVEL
HIGH LEVEL
Remote
Right Left
Volume X-over
Freq.
24dB/Oct
Phase
Power
ON
OFF
SuperNova
MK-V
Remote eye input
Manual
volume
control
Signal detection circuitry.
When the toggle switch is
in the ON position the
subwoofer is in AUTO
ON/OFF mode. When
in the OFF position the
amplifier is shut down
completely and must be
turned on manually for
operation. NOTE: When
the subwoofer is on the
power LED will remain
glowing red at all times.
It is not an indicator for
failure etc.
Variable, 24dB per
octave, low pass filter.
Range 50Hz-150Hz.
Recommended
general setting at 2
o'clock position
Fuse holder with two
replacement 10 ampere
fuses
Perfect to feed
a center
channel amp.
Connecting Your SuperNova
Low Level -RCA- Audio Input Connection:
This is the best way to drive an audio signal into the
. Today, all signal processors (5.1/6.1 and
more advanced ones) come equipped with built-in pre-
amplifier outputs (RCA) that include a subwoofer output.
Generally, the SUB/OUT is in mono format. Connect
the SUB/OUT from the processor to the using
a “Y” connector to feed both RCA inputs of the
. However, you can connect the
one RCA input as well.
We strongly recommend that you use the best
available RCA connectors and cables. High quality cables are
normally triple shielded and the connectors are gold plated
with forceful grasping.
SuperNova MKV
SuperNova MKV
SuperNova
MKV SuperNova MKV using
just
Connection from processor to MKV using a high
quality RCA Cable
High level audio input connection:
This is the least desired way to drive an audio signal
into the subwoofer. Older stereo systems are
not equipped with pre-amplifier audio outputs, normally they
come with stereo speaker outputs (left & right).
Using “banana” plugs, connect the speaker outputs to
the corresponding MKV high level inputs (marked “FROM
RECEIVER”).
SuperNova MKV
From
Receiver/
Pre Amp
To MKV
Low Level
Input