Electrolux LAVAMAT W 1050 - Manual (Page 21)

Operating Instructions
21
Changing the Spin Speed
The Spin Speed can still be changed or RINSE HOLD set, while the pro-
gramme is running.
0 1. Press the START/PAUSE button.
2. Change the spin speed with the Spin Speed/RINSE HOLD button.
3. Press the START/PAUSE button again. The washing programme contin-
ues.
Washing cycle complete/removing the washing
Once a washing programme cycle has come to an end, END illuminates
on the Programme Progress Display.
If RINSE HOLD was selected, the indicator lights beside DOOR and END
come on.
0 1. After a Rinse Hold, the water must first be drained:
– Either turn the programme selector to OFF, then turn to DRAIN and
press the START/PAUSE button (the water is drained without spin-
ning),
or
– turn the programme selector to OFF, then turn to SPIN and press the
START/PAUSE button (the water is drained and the washing given a
spin. The spin speed can also be changed during the spin cycle).
When this stage of the programme is completed, the END light
comes on.
2. Open the door.
The door can be opened after the DOOR light goes off and the END
light has come on.
3. Remove the washing.
4. Turn the programme selector to OFF.
5. Close the water tap.
6. After the washing cycle is completed, pull out the detergent dispenser
drawer slightly, to allow it to dry. Leave the door slightly open, to air
the inside of the washing machine.
Important! If the washing machine is not to be used for a long period:
Close the water tap and disconnect the washing machine from the
electricity mains.