Echo GT-230 - Manual (Page 9)

G
RASS
T
RIMMER
O
PERATOR
'
S
M
ANUAL
9
C
ONTENTS
The ECHO product you purchased has been factory pre-assembled for your convenience. Due to packaging restrictions,
shield installation and positioning of the front handle are necessary.
After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing
parts. Use the contents list to check for missing parts.
___ 1 - Trimmer Assembly
___ 1 - Power Head
___ 1 - Drive Shaft Assembly
___ 1 - Plastic Bag (Co-Pack)
___ 1 - Operator's Manual
___ 1 - Safety Manual
___ 1 - Shield Assembly
___ 1 - Locking Tool
___ 1 - Hardware Bag
___ - 1 , 1/4-20 bolt
___ - 1 , 1/4-20 wing nut
___ - 1 , 1/4-20 flat washer
___ 1 - Warranty Card & Limited Warranty
___ 1 - Safety Glasses
___ 1 - Echo Power Blend TM 2-stroke oil sample
A
SSEMBLY
Tools Required: Locking tool
PLASTIC SHIELD
1. Remove wing nut (C), washer (B), and bolt (A).
2. Snap the shield over the bearing housing.
3. Install bolt (A), washer (B) and wing nut (C).
NYLON LINE HEAD
1. Remove plastic sleeve from threaded shaft.
2. Align locating hole in locating plate with hole in bearing housing.
3. Insert 1/8" dia. locking tool (D) and thread cutting attachment onto
shaft clockwise until head is tight.
IMPORTANT
Remember to remove the locking tool.
A
B
C
D