Electrolux Gas Slide-in Range 318 203 890 (1001) - Manual (Page 46)

46
Solutions to Common Problems
oVen sMokes excessiVely duRinG bRoilinG
• Meat too close to the broiler burner. Reposition the rack to provide more clearance between the meat and
the broiler. Preheat broil burner for quick searing operation.
• Meat not properly prepared. Remove excess fat from meat. Cut remaining fatty edges to prevent curling, but
do not cut into the lean.
• Grid on broiler pan wrong side-up. Grease does not drain into broiler pan. Always place the grid on the
broiler pan with the ribs up and the slots down to allow grease to drip into the pan.
• Broiler pan used without grid or grid cover with aluminum foil. do not use the broiler pan without the grid
or cover the grid with aluminum foil.
• Oven needs to be cleaned. Grease has built up on oven surfaces. Regular cleaning is necessary when
broiling frequently. Grease or food spatters cause excessive smoking.
soil not coMPletely ReMoVed afteR self-cleaninG cycle is coMPleted
• Failure to clean bottom, from top of oven, frame of oven or door area outside oven seal. These areas are
not in the self-cleaning area, but get hot enough to burn on residue. Clean these areas before the self-
cleaning cycle is started. Burned on residue can be cleaned with a stiff nylon brush and water or a nylon
scrubber. Be careful not to damage the oven gasket.
• Excessive spillovers in oven. Set the self-clean cycle for longer cleaning time.
flaMes inside oVen oR sMoke fRoM Vent
• Excessive spillovers in oven. This is normal, especially for high oven temperatures, pie spillovers or for large
amounts of grease on bottom of oven. Wipe up excessive spillovers.
suRface buRneRs do not liGht
• Surface Control knob has not been completely turned to LITE. Push in and turn the Surface Control knob to
LITE until burner ignites and then turn control knob to desired flame size.
• Be sure gas supply valve is open.
• Burner ports are clogged. Clean burners. See Cleaning the Burner Grates, Burner Caps, Burner Heads
in General Care & Cleaning section. With the burner off, clean ports with a small-gauge wire or needle.
• Power cord is disconnected from outlet (Electric Ignition Models only). Be sure cord is securely plugged into the outlet.
• Electrical power outage (electric ignition models only). Burners can be lit manually. See setting surface
controls in this Use and Care Guide.
buRneR flaMe only liGhts half Way aRound buRneR
• Burner ports are clogged. With the burner off, clean ports by using a small-gauge wire or needle.
• Moisture is present after cleaning. Lightly fan the flame and allow burner to operate until flame is full. Dry
the burners thoroughly following instructions in the General Cleaning section.
food not heatinG eVenly
• Improper cookware. Select flat-bottomed cookware of a proper size to fit burner.
• Incorrect control setting. Raise or lower setting until proper amount of heat is obtained.
buRneR flaMe is oRanGe
• Dust particles in main line. Allow the burner to operate a few minutes until flame turns blue.
• In coastal areas, a slightly orange flame is unavoidable due to salt air. See ceramic-Glass cooktop
section in this Owner’s Guide.
• Cookware with rough bottom has been used. Use flat-bottomed, smooth utensils. See Selecting surface
cooking utensils in this Owner’s Guide.