Emerson EM6120-2 - Manual (Page 23)

Remote access
It is possible to access your messages and control the answering system
from anywhere using a standard telephone and the factory preset security
code (000), or you can select your own security code.
To remotely access your answering system:
1. Call the answering system.
2. After the outgoing message is played followed by a beep tone, slowly dial
the security code (000).
3. The answering system will confirm with two short beeps and will play-
back the remote voice guide.
4. Enter the correct code for the desired function (follow the chart below for
details regarding the remote voice commands).
To turn on the answering system from a remote location:
1. Call the answering system, the system will pick up after ten rings.
2. Dial the security code (000) after the message and beep tone.
3. Press “9”, a long beep confirmation will follow and the answering system
will be turned on.
To change the security code:
1. Press and HOLD the button until the system emits a
tone and the following voice prompt, “please set security code”.
2. Use the buttons to change the number up or down, and
press the button to confirm.
3. Repeat step number 2 until all three digits of the security
code are set and the answering system confirms the code
with a voice prompt of the new security code.
security
code
security
code
security
code
security
code
To check the security code:
• Press the button to check the security code
security
code
security
code
delete
“000”
rings to
answer
security
code
Press to check or press and HOLD
to adjust