Emerson EM529S User Manual

Page 2

NOTE: When the [Power] switch is set to the ON position for

the first time, the headset will be in Pairing Mode (the

indicator light will be flashing RED and BLUE alternately),

please refer to “Easy Pairing”.

Powering ON/OFF

• To turn ON, set the [Power] switch to the ON position (green).

The blue indicator light will flash intermittently.

• To turn OFF, slide the [Power] switch to the OFF position (red).

The indicator light will flash RED before the headset shuts

off.

Answering / Ending a call

• To answer a call, press and release the [Call] button or press

the answer key on your mobile phone.

• To end a call, press and release the [Call] button or press the

end key on your mobile phone.

Rejecting a call

During an incoming call press and HOLD the [Call] button

for 3 seconds or until you hear a confirmation beep.

Making a call

Dial the number and press the send button on your mobile

phone, the call is automatically transferred to the headset.

Redialing the last number called

(Dependent on your phone supporting this feature)

Press the [Call] button twice. The last number called will be

redialed.

Volume

To adjust the in-call volume, press the [Volume Up] or [Volume

Down] button.

NOTE: You may also adjust the volume from your mobile phone’s

volume control.

Mute

Press the [Volume Up] and the [Volume Down] button

simultaneously until you hear a beep, repeat to unmute the call.

For added comfort and noise suppression, 3 silicone cushions

are included with the headset. Choose the silicone cushion (S)

(M) (L) which fits most comfortably in your ear and insert it on

the headset as shown in the diagram below.

You may wear the headset with or without the provided earhook.

If you choose to use the earhook, connect it to the headset as

shown in the diagram below.

NOTE: For the best audio quality, always wear the headset on

the same side of your body as your mobile phone.

www.emersonphones.com

Distributed by Southern Telecom Inc. Brooklyn, NY 11232

Emerson and the G-Clef logo are registered trademarks of

Emerson Radio Corp. Parsippany, New Jersey USA.

The Bluetooth® word mark and logos are owned by the Bluetooth SIG, Inc.

SONY PlayStatiion® & PS3™ are either trademarks or registered

trademarks of SONY.

All other trademarks are trademarks of their respective owners.

Limited Warranty

In the unlikely event that this product is defective, or does

not perform properly, you may within one (1) year from your

original date of purchase return it to the authorized service

center for repair or exchange.

TO OBTAIN WARRANTY SERVICE:

• Provide proof of the date of purchase within the package

(Dated bill of sale).

• Prepay all shipping costs to the authorized service center,

and remember to insure your return.

• Include a return shipping address (no P.O. Boxes),

a telephone contact number, and the defective unit within

the package.

• Describe the defect or reason you are returning the product.

Your product will be repaired or replaced, at our option, for the same

or similar model of equal value if examination by the service center

determines this product is defective. Products received damaged

as a result of shipping will require you to file a claim with the carrier.

Warranty service not provided

This warranty does not cover damage resulting from accident,

misuse, abuse, improper installation or operation, lack of reasonable

care, and unauthorized modification. This warranty is voided in

the event any unauthorized person opens, alters or repairs this

product. All products being returned to the authorized service

center for repair must be suitably packaged.

Limitation of Warranty:

• THE WARRANTY STATED ABOVE IS THE ONLY WARRANTY

APPLICABLE TO THIS PRODUCT. ALL OTHER WARRANTIES,

EXPRESS OR IMPLIED (INCLUDING ALL IMPLIED WARRANTIES OF

MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE) ARE

HEREBY DISCLAIMED. NO VERBAL OR WRITTEN INFORMATION

GIVEN BY SOUTHERN TELECOM INC. IT’S AGENTS, OR EMPLOYEES

SHALL CREATE A GUARANTY OR IN ANY WAY INCREASE THE

SCOPE OF THIS WARRANTY.

• REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY

IS THE EXCLUSIVE REMEDY OF THE CONSUMER. SOUTHERN

TELECOM INC. SHALL NOT BE LIABLE FOR INCIDENTAL OR

CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS

PRODUCT OR ARISING OUT OF ANY BREACH OF ANY EXPRESS

OR IMPLIED WARRANTY ON THIS PRODUCT. THIS DISCLAIMER

OF WARRANTIES AND LIMITED WARRANTY ARE GOVERNED

BY THE LAWS OF THE STATE OF NEW YORK. EXCEPT TO THE

EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED

WARRANTY OF MERCHANTABILITY OR FITNESS FOR A

PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED TO

THE APPLICABLE WARRANTY PERIOD SET FORTH ABOVE.

Some states do not allow the exclusion nor limitation of incidental

or consequential damages, or limitations on how long an implied

warranty lasts so the above limitations or exclusions may not apply

to you. This warranty gives you specific legal rights, and you

also may have other rights that vary from state to state.

Should you have any questions or problems concerning this

product, please contact our customer service department at:

1-877-768-8483 (Toll Free)

Monday - Thursday: 9AM - 5PM (EST)

Friday: 9AM - 3PM (EST)

via e-mail at

[email protected]

Southern Telecom, Inc.

ATTN: Customer Service - 2nd Floor

14-C 53rd Street

Brooklyn, NY 11232

The shipping address of the authorized service center is:

FCC Part 15

This equipment has been tested and found to comply with the

requirements for a Class B digital device under Part 15 of the

Federal Communications Commission (FCC) rules. These

requirements are intended to provide reasonable protection

against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

• Re-orient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Do not attempt to repair or modify this equipment.

Warning: Changes or modifications to this equipment not

expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

Operation is subject to the following two conditions: (1) This

device may not cause interference and (2) This device must

accept any interference, including interference that may

cause undesired operation of the device.

The term “IC:” before the certification/registration number

only signifies that registration was performed based on a

Declaration of Conformity indicating that Industry Canada

technical specifications were met. It does not imply that

Industry Canada approved the equipment.

• Try adjusting the volume by using the [Volume Up] or

[Volume Down] button on the headset; make sure the

volume on your mobile phone is turned up as well.

• For the best audio quality, always wear the headset on the same

side of the body as your mobile phone.

• Check that the battery is charged enough.

• Try turning the headset OFF, and then turning it ON again.

• Many mobile phones have an auto reconnect option when first

attempting to reconnect to a newly paired Bluetooth device.

Make sure you accept this option, so that the headset

automatically reconnects to your mobile phone; check the user

guide of your mobile phone for more information regarding

this option.

• Try unpairing the headset from your phone, and repeat the

pairing procedure.

• Make sure that you fully charged the headset before pairing.

• Keep the headset and mobile phone within 3 feet of each

other during the pairing process.

• Check that your phone’s Bluetooth feature is turned ON.

• Try removing the battery from your mobile phone for 5 minutes.

Place the battery back in the phone, power it on, and retry the

pairing process (see “Manual Pairing”).

• Try repeating the pairing process, see “Manual pairing.”

• Make sure the headset is turned on before beginning the

pairing process (the headset is in pairing mode when you

turn it on for the first time).

• If you are not pairing for the first time or for manual pairing,

press and HOLD the [Call] button until the indicator light

flashes RED and BLUE alternately.

I cannot get the headset into Pairing Mode

My mobile phone cannot pair with the headset

After successfully pairing my mobile phone

and headset, when I shut the phone and

turn it on again, the headset did not

automatically reconnect

I hear distortion, and the sound quality is

poor

The sound is very low

Silicone cushions

S M L

Earhook

Volume Up

Volume Down

Power Switch

Power ON

(Green)

Power Switch

Power OFF

(Red)

Indicator light

Right ear

Left ear

Using the headset

Wearing your Bluetooth Headset

Stereo Bluetooth

Playing music and video

Troubleshooting tips

FCC and telephone company information

Industry Canada

Warranty information

Call button

Answer/end a call

Call button

Press twice to redial

Indicator light

This headset allows you to listen (in full stereo) and control* the

music and video on your Bluetooth enabled mobile phone,

gaming console, computer or mp3 player and supports the

following Bluetooth profiles:

•

A2DP - Advanced Audio Distribution Profile

•

AVRCP - Audio/Video Remote Control Profile

•

HSP - Headset Profile

•

HFP - Handsfree Profile

To use the headphones to listen to and control music and video,

your Bluetooth enabled device must support the A2DP and AVRCP

profiles. Please refer to the user guide of your Bluetooth enabled

device for more information.

Connect the Stereo earphone to the Bluetooth Headset’s charging

socket as shown below.

Insert the Bluetooth Headset in one ear, and wrap the Stereo

Earphone behind your neck and insert it into your other ear.

To enjoy music and video using your Bluetooth Headset,

press the [Play] button of your Bluetooth enabled device to

begin music playback. Once playback has begun, you can

control the music and videos, or answer phone calls from

the control buttons of the Bluetooth Headset (Not all mobile

phones support the control of music using Bluetooth).

Adjusting the volume

Press the [Volume Up] or [Volume Down] button to adjust the

volume to the desired level.

NOTE: You may also adjust the volume from your mobile phone’s

volume control.

Play/Pause* (music and video)

While the music or video is playing, press the [Call] button to

pause. To resume playback, press the [Call] button again.

Skipping or searching* (music or video)

While the music or video is playing, press and HOLD the

[Volume Up] button to go to the previous song, or press and

HOLD the [Volume Down] button to go to the next song.

Answering a call while media is playing

During an incoming call, press the [Call] button to answer.

Press the [Call] button again to end the call and return to media

playback.

*Certain Bluetooth features including those listed may not

be supported by all compatible Bluetooth-enabled devices,

and/or the functionality of such features may be limited in

certain devices.

Stereo

earphone

Charging

socket

Volume Down

Volume Up

Press simultaneously

to mute and unmute

Volume Up

(Press and HOLD)

Previous song

Volume Down

(Press and HOLD)

Next song

Call button

Play/Pause