Englishenglishenglishenglishenglish, Model edw242c operating instructions, Edw242c programs – Eurotech Appliances EDW294E User Manual
Page 21: Control panel

21
ENGLISHENGLISHENGLISHENGLISHENGLISH
ON/OFF BUTTON
Press the this button, “The LED corresponding to the
last wash cycle performed lights up”
INDICATOR PROGRAM LIGHTS
The ON lights indicate which cycle is currently in
progress.
PROGRAM BUTTON
When you press the button for the first time, you
confirm the wash cycle that corresponds to the
flashing LED. The next time you press the button,
the LED of the program that corresponds to the wash
cycle you intend to select will light up. At the end of
the cycle, the selected program flashes.Select the
program which you believe is best suited to the types
of dishes which need to be washed.
START BUTTON
Press button with the appliance door shut, the wash
cycle will start and the LED on the button itself will
light up.
INDICATOR “ON” LIGHTS
The light to indicate the power is on.
CANCELLING A PROGRAM
To modify a wash cycle in progress, you must press
the Start button for approximately 6 seconds;
subsequently, the LED of the selected program
begins to flash. The RESET phase will end when the
Start button LED goes off. At this point, the appliance
is ready to be set again.
If you forget to put a dish in, you can interrupt the
wash cycle (preferably only if it hasn’t been running
for long) by pressing the Start button which then
flashes; open the appliance door and place the dish
inside. To restart the appliance, close the door
and press the Start button again; the cycle will
resume from the point in which it was interrupted.
To repeat the same cycle, press the program button
and then the Start button.
Before you restart the unit, make sure the detergent
dispenser is still closed; otherwise, you will have to
add detergent. (Please note that if the program has
run beyond the fill phase, the water will be pumped
out.)
Wash
Rinse
Wash
Temps (° F)
Temp
Program
Normal
(° F)
Recommended Loads
Soak (& hold)
House
For extra-heavily soiled loads that require a
presoak, such as pans or baked-on casseroles
Light
105
105
Light soiled loads
Normal
130
130
Normally soiled loads
Pots & Pans
150
140
Heavily soiled loads, such as pans or casseroles
EDW242C PROGRAMS
On / Off
1
2
3
4
PROGRAMS
START
4
Pots & Pans
3 Normal
2 Light
1 Soak & Hold
ON
On / Off Button
Programs
Program Button
Indicator program lights
Start Button
MODEL EDW242C OPERATING INSTRUCTIONS
CONTROL PANEL