Edge Craft 120 - Manual (Page 12)

12
®
NORMAL MAINTENANCE
No lubrication is required for any moving parts, motor, bearings or sharpening surfaces. There
is no need for water on abrasives. The exterior of the sharpener may be cleaned by carefully
wiping with a damp cloth. Do not use detergents or abrasives.
Once a year or so, as needed, you can remove metal dust that will accumulate inside the sharp-
ener from repeated sharpenings. Remove the small rectangular clean-out cover (Figure 14) that
covers an opening on the underside of the sharpener. You will find metal particles adhered to a
magnet attached to the inside of that cover. Simply rub off or brush off accumulated filings from
the magnet with a paper towel or tooth brush and reinsert the cover in the opening. If larger
amounts of metal dust have been created or if the Stage 3 disk has been cleaned (using the
cleaning/dressing means), you can shake out any remaining dust through the bottom opening
when the cover is removed. After cleaning, replace the cover securely with its magnet in place.
SERVICE
In the event post-warranty service is needed, return your sharpener to the EdgeCraft factory
where the cost of repair can be estimated before the repair is undertaken. Outside the USA,
contact your retailer or national distributor.
Please include your return address, daytime telephone number and a brief description of the
problem or damage on a separate sheet inside the box. Retain a shipping receipt as evidence
of shipment and as your protection against loss in shipment.
Figure 14. Clean-out cover.
EdgeCraft Corporation
825 Southwood Road
Avondale, PA 19311
Customer Service 610-268-0500
Assembled in the U.S.A. U.S.Patents 4,807,399, 5,611,726, 6,012,971, 6,113,476, 6,267,652, and D,409,891.
Other U.S. and foreign patents pending.
Conforms to: UL 982
Certified to CAN/CSA: C22.2 No. 1335.2.14
© 2007 EdgeCraft Corporation
C128200 www.edgecraft.com I07