Step 4 - outer bag, Step 5 - bag support, Step 6 - cord storage – Eureka 600 User Manual

Page 6

Text mode
Original mode

Step 4 - Outer Bag

Hold outer bag with zipper away from
handle.

Important: To provide a

good gasket seal, the bag
coupling must seat firmly against
the motor base and not overlap
the furniture guard.

Start the bag

screws D by hand, then tighten with
a screwdriver.

Step 5 - Bag Support

Loop the spring F onto the bag
support G, located to the back of the
upper cord hook.

Step 6 - Cord Storage

Secure the cord in the guide below the
upper cord hook as shown or secure
the cord into the side of the upper cord
hook.

Secure cord into lower cord hook. Pull
up on cord to tighten but leave slack
near the base so the cord does not
strain when the handle is lowered for
use. Wrap the cord around the cord
hooks. Fasten the plug to the cord to
prevent unwinding.

Upper Cord

Hook

Upper

Guide

Lower Cord

Hook

C–