Epson PowerLite 850p - Manual (Page 5)

5
Setting Up Your Macintosh
Before you begin, do the following:
■ Configure your projector for wireless projecting; see the User’s
Guide for instructions.
■ Insert the EPSON wireless (802.11b) card in the projector and
start EasyMP.
™ See the User’s Guide for details.
Follow these steps to set up your Macintosh for wireless projecting:
1. From the Apple pull-down menu, select System Preferences .
Then double-click the Network icon. You see the Network
Settings window.
2. Select Network Port Configuration in the Show pull-down
menu:
3. Under Port Configurations , select AirPort .
4. Click Apply Now . Then close the window.
note
Don’t set your projector to
Channel ad hoc mode. This
mode is not supported for
Macintosh.
then select AirPort
Select Network
Port Configurations
here. . .
note
If you don’t need the other
network ports, disable them
by deselecting their check
boxes. If more than one
network port is enabled, the
projector software warns
you to turn off AirPort
when you first connect to
the projector. Disregard this
message.