Electrolux EN EWW 168543 W - Manual (Page 11)

After closing the door, it is necessary to se-
lect the programme and options again and
to press button 8.
AT THE END OF THE PROGRAMME
The machine stops automatically. Three
blinking zeros (
) appear on the dis-
play.
The pilot light of button 8 goes off. Some
acoustic signals sound for a few minutes.
If a programme or an option that ends with
water left in the tub has been set, the icon
2.8 remains displayed to indicate that the
water must be emptied out before opening
the door.
The drum continues to run at regular inter-
vals until the water draining.
Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to
.
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4. Press button 8.
At the end of the programme, the icon 2.8
disappears and the door can be opened.
Turn the programme selector dial to
to
switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap. Leave the door
open to prevent the formation of mildew
and unpleasant smells.
Stand by : once the programme has finish-
ed after a few minutes the energy saving
system will be enabled. The brightness of the display is reduced. By pressing any but-
ton the appliance will come out of the ener-
gy saving status.
USE - DRYING
DRYING ONLY
Warning!
The recommended load size is 4 kg for cot-
tons and linen, 3 kg for synthetic items and
1.5 kg for wool.
Important! For wool items the timed drying
is the only drying available (Drying Time
button).
By pressing Drying Time button it is
also possible to dry up to 6 kg of cot-
ton items (see the «Drying Pro-
gramme » table).
Warning!
The water tap must be open and the
drain hose must be positioned in the
sink or connected to the drain pipe.
1. Load the laundry.
2. Select a spin cycle at the maximum
spin speed allowed for the type of laun-
dry in order to obtain the best drying
performances.
3. Select the drying programme for Cot-
tons, Synthetic or Wool in the Drying
sector of the programme selector dial.
4. If you wish to select an automatic dry-
ing (for cottons and synthetic items on-
ly), press the button 5 until the icon
corresponding to the required dryness
degree appears on the display marked
with the icon
.
5. If you wish to select a timed drying,
press the button 6 until the time you
want appears on the display (see the
«Drying Programme» table). Every time
you press this button the drying time in-
creases by 5 minutes.
Note!
The programme time will automatically
increase by some minutes.
6. Press button 8 to start the programme.
The time remaining is updated every
minute.
electrolux 11