Echo SRM - 2110 User Manual

Page 28

NOTE
The throttle linkage remains assembled to the cover and the spark
plug lead and grommet remain installed.

3. Use the wooden stick or brush to remove dirt form cylinder fins.

4. Remove grass and leaves from the grid between the recoil starter

and fuel tank.

5. Assemble components in reverse order.

NOTE
When installing the cover, be certain the tab of the metal deflector
shield is in the slot of the engine cover.

EXHAUST

SYSTEM

Spark Arrestor Screen

Level 2.
Tools required: Cross-head screwdriver, soft metal brush, wooden
carbon scraper.
Parts Required: Screen P/N 14586240630, Gasket Lid P/N
14586642031

1. Remove engine cover (A). See “Cleaning Cooling System” pages

27 & 28 for step by step instructions.

2. Place piston at Top Dead Center (TDC) to prevent carbon/dirt from

entering cylinder.

3. Remove spark arrestor screen cover (B), screen holder (C), gasket

(D) and screen (E) from muffler body.

4. Clean carbon deposits from screen and muffler components.

5. Replace screen if it is cracked, plugged or has holes burned

through.

6. Assemble components in reverse order

NOTE
When installing the engine cover, be certain the tab of the metal
deflector shield is in the slot of the engine cover.