beautypg.com

Enerco HSIR30LPT User Manual

Page 11

background image

11

Installation Instructions and Owner’s Manual

Unvented Liquid Propane Fired Room Heater

TO TURN OFF GAS TO APPLIANCE

SHUTTING OFF HEATER:

1. Turn control knob clockwise to the OFF posi-

tion.

2. Turn off all electrical power to the appliance if

servicing is to be preformed.

3. Turn off equipment shutoff valve.

SHUTTING OFF BURNER ONLY (PILOT STAYS LIT)

1. Turn control knob clockwise to the PILOT/IGN

position.

OPERATING YOUR HEATER

THERMOSTAT MODELS
IR20LPT, IR30LPT, BF20LPT, BF30LPT,
FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING: If you do not follow these instructions

exactly, a fire or explosion may result causing prop-

erty damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted

by pushing the ignitor button. When lighting the

pilot, follow these instructions exactly.

B. BEFORE LIGHTING smell all around the appli-

ance area for gas. Be sure to smell next to the

floor because some gas is heavier than air and

will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electrical switch; do not use

any phone in your building.

Immediately call you gas supplier from a neigh-

bor’s phone. Follow the gas supplier’s instruc-

tions.

If you can not reach your gas supplier, call the

fire department.

C. Use only your hand to push in or turn the gas

control knob. Never use tools. If knob will not

push in or turn by hand, don’t try to repair it call

a qualified service technician or gas supplier.

Force or attempted repair may result in a fire or

explosion.

D. Do not use this appliance if any part has been

underwater. Immediately call a qualified service

technician to inspect the appliance and to re-

place any part of the control system which has

been underwater.

LIGHTING INSTRUCTIONS

1. STOP! Read the all safety information included

with and on the side of heater.

2. Make sure the equipment shutoff valve is fully

open.

3. Push in gas control knob and slightly turn clock-

wise to the OFF position (see figure 19).

4. Wait five (5) minutes. Then smell for gas includ-

ing near the floor. If you smell gas, STOP! Fol-

low “B” in the safety information above. If you

do not smell gas, go to the next step.

5. Push in and turn control knob counterclockwise

to PILOT/IGN. Press in control knob for five (5)

seconds.

Note: The first time that the heater is operated after

connecting the gas supply, the control knob should

be depressed for about 30 seconds. This will allow

air to bleed from the gas system.

Figure 19.

6. With control knob pressed in, push down and

release the ignition button. This will light pilot. If

needed keep pressing igniter button until pilot

lights.

7. Keep control knob pressed in for (30) seconds

after lighting pilot. After 30 seconds, release

control knob.

Figure 20

• If pilot does not stay lit, refer to Troubleshoot-

ing, pages 14 & 15. Also, contact a qualified

service person of gas supplier for repairs.

If control knob does not pop up when released,

contact a qualified service person or gas sup-

plier for repairs.

Ignitor Button

Control Knob

This manual is related to the following products: