Electrolux 62825 - Manual (Page 18)

18
Door and rubber collar
Regularly check whether deposits or foreign bodies are present in the
folds of the rubber collar or on the inside of the glass door.
Clean the glass in the door and the rubber collar regularly.
What to do if...
Remedying small faults yourself
If during use of the appliance one of the following error codes is shown
in the multi-display:
– E10 (Problems with the water inflow),
– E20 (Problems with the water outflow),
– E40 (door open),
please consult the following table.
After the error has been remedied, press the START/PAUSE button.
In the event of other errors (E and a number or letter): Switch the ap-
pliance off and then on again. Set the programme again. Press the
START/PAUSE button.
If the error appears again, please contact your local Service Force Cen-
tre, stating the error code.
Problem Possible cause Remedy
Washing machine does
not work.
Power plug not plugged in
or problem with the fuse. Connect the plug to a mains
socket. Check the fuse.
The door is not shut proper-
ly. Close the door until the lock
audibly clicks into place.
The START/PAUSE button
was not pressed for long
enough. Press the START/PAUSE but-
ton for a longer period of
time.
The door cannot be
closed. The child safety device is ac-
tivated. Deactivate the child safety
device:
When you press a but-
ton Err appears in the
multi-display. The selected function can-
not be used together with
the wash programme set.
Select another function.
E40 appears.
The END indicator is
flashing 4 times, and si-
multaneously an acous-
tic signal is sounding 4
times.
The door is not closed prop-
erly. Close the door properly. Re-
start the programme.