Electrolux Ceramic Glass Hob EHS601210P - Manual (Page 27)

what to do if … electrolux 27
What to do if …
Problem Possible cause Remedy
The cooking zones cannot be
switched on or are not operat-
ing More than 10 seconds have
passed since the appliance
was switched on Switch the appliance on again.
The child safety device is
switched on Deactivate child safety device
(See the section “Child safety
device”)
Several sensor fields were
touched at the same time Only touch one sensor field
Automatic switch-off has been
triggered Remove any objects (pan,
cloths, etc.) that are lying on
the control panel. Switch ap-
pliance on again
There is water on the control
panel or the control panel is
covered with fat splashes Wipe the control panel
Acoustic signal sounds when
appliance is switched off The control panel is wholly or
partly covered by objects. Remove objects.
There is water on the control
panel or the control panel is
covered with fat splashes Wipe the control panel
The residual heat indicator is
not displaying anything The cooking zone was only on
for a short time and is therefore
not hot If the cooking zone is sup-
posed to be hot, call the Cus-
tomer Service Department.
The signal sounds and the ap-
pliance turns itself on, then off
again after 5 seconds. After
another 5 seconds the signal
sounds again. Something is covering the On/
Off sensor field Do not put any objects on the
control panel
lights up Automatic switch-off has been
triggered Switch off the cooking zone.
Switch the cooking zone on
again
and a number is displayed Electronics fault Disconnect appliance from the
electrical supply for a few min-
utes. (Take the fuse out of the
house’s wiring system.)
If you still see
and a number
after switching the appliance
back on, call the Customer
Service Department