Electrolux Z425 Series - Manual (Page 5)

5
On/Off Switch
1
2
3
5
6
7
4
8
Lock
Position
HO
W
TO USE
ROUTINE MAINTENANCE
Empty Dust Cup
HOW TO USE
Power Switch
1. This vacuum has a 3-position switch. O is Off, I is “Suction Only,”
and II is “Suction and Brushroll.”
2. For bare floor cleaning use suction only (I). For carpet cleaning,
use suction and brushroll (II).
The nozzle allows for low profile cleaning. Airflow under the nozzle
automatically directs suction to the edges and corners for maximum
full width cleaning.
ROUTINE MAINTENANCE
The instructions in this booklet serve as a guide to routine
maintenance. To keep the cleaner operating at top efficiency empty
the dust cup and clean the filter after each use. To maximize cleaner
efficiency do not allow the dust cup to be filled past the bottom of
the filter.
Empty Dust Cup
CAUTION: Turn off the power switch and unplug the
electrical cord to service.
3. Push dust cup release button.
4. Pull the dust cup away from the main housing.
5. Rotate the dust cup lid counterclockwise to remove. The dust
cup filter comes out with the dust cup lid.
6. Empty the dust cup into a waste container. (To clean filter refer
to dust cup filter section.)
7. Put the lid back on dust cup. Be sure the gasket on the filter
bottom is centered in the inner tube and the lid is aligned correctly
on the cup. Rotate the dust cup lid clockwise until it locks.
8. Place the bottom of the dust cup in the main housing. Push the
top of the dust cup back into place until it locks.