Electrolux LAVAMAT 50810 - Manual (Page 28)

28
• If the location in which the appliance is to be installed is fitted with
small-format tiles, put a rubber mat (available in the shops) under
the appliance.
If the appliance is to stand on a
base:
In order for the appliance to be se-
cure on the base, fixing plates*)
must be mounted, into which the
appliance is inserted.
If the appliance is to stand on a floor which moves, e.g. a suspend-
ed wooden floor:
Place the appliance in an area as close as possible to a corner of the
room.
Screw a water-resistant wooden board (at least 15 mm thick) onto at
least 2 of the floor joists.
Making the appliance level
The four feet of the appliance are
pre-adjusted.
Large degrees of unevenness can be
compensated for by individually ad-
justing the height adjustable screw
feet.
Use the special spanner supplied to
do this.
Important! Do not use pieces of
wood, cardboard or such like to lev-
el out unevenness in the floor, but
adjust the height adjustable screw
feet instead.