EdgeStar IB450SS - Manual (Page 6)

IMPORTANT SAFEGUARDS
Before the ice maker is used, it must be properly positioned and installed as
described in this manual, so read the manual carefully. To reduce the risk of
fire, electrical shock or injury when using the ice maker, follow basic
precautions, including the following:
z Plug into properly grounded outlet, do not use an adapter, and do not use an extension
cord.
z It is recommended that a separate circuit, serving only your ice maker, be provided. Use
receptacles that cannot be turned off by a switch or pull chain.
z Do not connect or disconnect the electric plug when your hands are wet.
z Never clean ice maker parts with flammable fluids. These fumes can create a fire
hazard or explosion. And do not store or use gasoline or other flammable vapors and
liquids in the vicinity of this or any other appliance. The fumes can create a fire hazard
or explosion.
z Before proceeding with cleaning and maintenance operations, make sure the power line
of the unit is disconnected and the water line is shut off
z Replace all panels before operating after servicing or maintenance.
z Unplug the ice maker or disconnect power before cleaning or servicing. Failure to do so
can result in electrical shock or death.
z Do not attempt to repair or replace any part of your ice maker unless it is specifically
recommended in this manual. All other servicing should be referred to a qualified
technician.
z Use two or more people to move and install ice maker. Failure to do so can result in a
back injury or other injury.
z To ensure proper ventilation for your ice maker, Choose a well-ventilated area with
temperatures above 50°F and below 100°F. This unit MUST be installed in an area
protected from the elements, e.g., wind, rain, water spray or drips.
z The ice maker should not be located next to ovens, grills or other sources of high heat.
z The ice maker must be installed with all electrical, water and drain connections in
accordance with state and local codes. A standard electrical supply (115 V, 60 Hz,),
properly grounded in accordance with the National Electrical Code and local codes and
ordinances is required.
z Do not kink or pinch the power supply cord between the ice maker and cabinet.
z The fuse (or circuit breaker) size should be 3 amp.
z It is important for the ice maker to be leveled in order to work properly. You may need
to make several adjustments to level it.
z All installations must be in accordance with local plumbing code requirements.
z Make certain that the pipes are not pinched or kinked or damaged during installation.
z Check for leaks after water line connection.
z Never allow children to operate, play with or crawl inside the ice maker.
z Although the unit has been tested at the factory, due to long-term transit and storage, the
6