Electrolux MCD1762E - Manual (Page 36)

36 Installation
Safe use of the appliance
If fitting the microwave in position B or C (See diagram on page 35):
• The cupboard must be a minimum of 500 mm (E) above the worktop and
must not be installed d diirreeccttllyy above a hob.
• This appliance has been tested and approved for use near domestic gas,
electric and induction hobs only.
• Sufficient space between hob and microwave should be allowed to prevent
overheating of microwave oven, surrounding cupboard and accessories.
• Do not operate the hob without pans when the microwave oven is
operating.
• Care should be taken when attending to the microwave oven while the hob
is on.
IIm mp po orrttaan ntt:: EEn nssu urree tth hee b bo otttto om m o off tth hee o ovveen n iiss 8 85 5 ccm m o orr m mo orree aab bo ovvee tth hee ffllo oo orr..
IItt iiss iim mp po orrttaan ntt tto o een nssu urree tth haatt tth hee iin nssttaallllaattiio on n o off tth hiiss p prro od du ucctt cco on nffo orrm mss tto o
tth hee iin nssttrru uccttiio on nss iin n tth hiiss o op peerraattiio on n m maan nu uaall aan nd d tth hee cco on nvveen nttiio on naall o ovveen n
m maan nu uffaaccttu urreerr’’ss iin nssttaallllaattiio on n iin nssttrru uccttiio on nss..
Connecting the appliance to the power supply
• • TTh hee eelleeccttrriiccaall o ou uttlleett ssh ho ou ulld d b bee rreeaad diillyy aacccceessssiib bllee sso o tth haatt tth hee
u un niitt ccaan n b bee u un np pllu ug gg geed d eeaassiillyy iin n aan n eem meerrg geen nccyy.. O Orr iitt ssh ho ou ulld d b bee
p po ossssiib bllee tto o iisso ollaattee tth hee o ovveen n ffrro om m tth hee ssu up pp pllyy b byy iin ncco orrp po orraattiin ng g aa
ssw wiittcch h iin n tth hee ffiixxeed d w wiirriin ng g iin n aacccco orrd daan nccee w wiitth h tth hee w wiirriin ng g rru ulleess..
• • TTh hee sso occkkeett ssh ho ou ulld d n no ott b bee p po ossiittiio on need d b beeh hiin nd d tth hee ccu up pb bo oaarrd d..
• The best position is above the cupboard, see (A).
• Connect the appliance to a single phase 230-240 V/50 Hz
alternating current via a correctly installed earth socket.
• • TTh hee p po ow weerr ssu up pp pllyy cco orrd d m maayy o on nllyy b bee rreep pllaacceed d b byy aan n eelleeccttrriicciiaan n..
• Before installing, tie a piece of string to the power supply
cord to facilitate connection to point (A) when the appliance
is being installed.
• When inserting the appliance into the high-sided cupboard,
DO NOT crush the power supply cord.
• Do not immerse the power supply cord or plug in water or
any other liquid.
(A)