Whirlpool 24 Inch Over-the-Range Microwave Hood Combo Owner's Manual - Manual (Page 6)

6
MICROWAVE OVEN CONTROL
Display
When power is fi rst supplied to the microwave oven, “:” will
appear in the display. If the “:” appears in the display at any other
time, the clock is not set, or there has been a power failure. Reset
the clock if needed. See “Clock.”
When the microwave oven is in use, the display will show cook
time remaining. When the microwave oven is not in use, the
display will show the time of day (if the clock is set).
Start
The Start control begins any function. If cooking is interrupted by
opening the door, pressing the Start control will resume the cycle,
within 10 minutes of interruption.
The Start control also automatically starts the microwave oven at
full power (750W) for 30 seconds, and adds 30 seconds of cook
time with each additional touch of the control.
Time may be added to any manual cooking cycle in 30-second
increments, at the current power level, by pressing the Start
control during cooking.
NOTE: To avoid unintentional operation of the microwave oven,
a cooking function cannot be started if the microwave oven door
has been closed for about 1 minute. The word “door” will appear
in the display until the door is opened and closed.
Stop
The Stop control clears any incorrect command, and cancels any
program during cooking.
The microwave oven will also turn off when the door is opened.
Close the door and press Start control to resume the cycle.
Time Entry
The +/- control is used to enter time for setting the clock and for
programming cooking cycles. The following represents the
control press time increments.
NOTE: Press and hold +/- control to jump to 10 minutes.
Timer
The microwave oven may be used as a kitchen timer by using
zero power (0W).
To Set:
1. Press +/- controls to set desired time. Each press adds or
removes 5 seconds from the current time.
2. Press Power Level control repeatedly until 0W appears in the
display.
3. Press Start control.
When the set time ends, a tone will sound.
The time can be reset during the countdown by pressing the +/-
control repeatedly.
Clock
This is a 12-hour clock.
NOTE: If there is a power failure, the clock will have to be reset.
To Set:
The microwave oven must be off (in standby mode).
1. Press and hold Stop control for about 3 seconds, until the
left-hand digits in the display blink.
2. Press the +/- controls to set the hour.
3. Press Start control. The right-hand digits will blink.
4. Press the +/- controls to set the minutes.
5. Press Start control to complete the setting.
To Remove:
1. Press and hold Stop control for about 3 seconds, until the
left-hand digits in the display blink.
2. Press Stop control. The time will disappear, and “:” will
appear on the display.
Language/Weight Entry
The microwave oven display’s language and weight entry mode
may be changed using Customer Settings.
The default language is English, but may be changed to French.
The default weight entry mode is grams, but may be changed to
ounces.
NOTE: If there is a power failure, the language and weight entry
mode will return to the default settings.
Each Press Adds Up to
5 seconds 1 minute
15 seconds 3 minutes
30 seconds 6 minutes
s e t u n i m 0 3 e t u n i m 1
+