Electrical, Installation requirements – Wolf 24 Inch Microwave Drawer Installation Instructions User Manual
Page 4
4
|
Wolf Customer Care 800.222.7820
Electrical
Installation must comply with all applicable electrical codes.
Locate the electrical supply as shown in the illustrations on
the following pages. The receptacle may also be located
in an adjacent cabinet within reach of the power cord. A
separate circuit, servicing only this appliance is required. A
ground fault circuit interrupter (GFCI) is not recommended
and may cause interruption of operation. Refer to the illustra-
tion below for minimum power cord plug clearance.
WARNING
ELECTRICAL SHOCK HAZARD: Plug into a grounded
3-prong outlet. Do not remove ground prong. Do not use
an adapter or extension cord. If the power cord is too
short, have a qualified electrician or service technician
install an outlet near the appliance. Failure to follow these
instructions can result in electric shock, fire or death.
ELECTRICAL REQUIREMENTS
Electrical Supply
grounded, 120 VAC, 60 Hz
Service
15 amp dedicated circuit
Receptacle
3-prong grounding-type
Power Cord
4'
(1.2 m)
GROUNDING INSTRUCTIONS
This appliance must be grounded. The microwave oven is
equipped with a cord having a grounding wire with a grounding
plug. It must be plugged into a wall receptacle that is prop-
erly installed and grounded in accordance with the National
Electrical Code and local codes and ordinances. In the event
of an electrical short circuit, grounding reduces risk of electric
shock by providing an escape wire for the electric current.
SPECIFICATIONS
Installation Requirements
The drawer microwave oven can be installed in a standard
or flush inset application. Location of the electrical supply
within the oven opening may require additional cabinet
depth.
Finish the edges of the opening. They may be visible when
the drawer is open.
For standard installations, face trim will overlap stiles and
rails. Refer to the chart below.
For flush inset installations, a minimum
1
/
8
"
(3)
reveal is
required on the top and sides and
11
/
16
"
(18)
on the bottom.
To ensure consistent reveals, each corner of the opening
must be exactly 90°. A sales accessory is required to direct
air away from the unit. Accessories are available through an
authorized Wolf dealer. For local dealer information, visit the
find a showroom section of our website, wolfappliance.com.
ANTI-TIP BLOCKING
To reduce the risk of tipping, the drawer microwave oven
must be secured in place by anti-tip blocking. The anti-tip
blocking must be provided by the installer. Dimensions will
vary with the installation. Refer to the illustrations on the
following pages.
INSTALLATION REQUIREMENTS
BASE SUPPORT
MIN
24" Model
125 lb
(57 kg)
30" Model
125 lb
(57 kg)
TRIM OVERLAP
24" MODEL
30" MODEL
Top
5
/
16
"
(8)
5
/
16
"
(8)
Bottom
1
/
16
"
(2)
1
/
16
"
(2)
Sides
7
/
8
"
(22)
3
7
/
8
"
(98)
RATING
PLATE
3"
(76)
MINIMUM CORD
CLEARANCE
Power cord clearance.
Rating plate location.