beautypg.com

Cleaning and maintenance, Oven surfaces, Interior – Viking 24 Inch Countertop Microwave Oven Use and Care User Manual

Page 25: Glass surfaces, Stainless steel parts, Control panel, Odor removal, Turntable/turntable support, Waveguide cover

background image

23

E

Any piece of equipment works better and lasts longer when maintained properly and kept clean. Cooking equip-
ment is no exception. Your Microwave Oven must be kept clean and maintained properly.
Disconnect the power cord before cleaning or leave the door open to inactivate the oven during cleaning.

Oven Surfaces

The outside surface is precoated metal and plastic. Clean the outside with mild soap and water; rinse and dry with a soft
cloth. Do not use any type of household or abrasive cleaner. Metal parts will be easier to maintain if wiped frequently with a
damp cloth. Avoid the use of spray and other harsh cleaners as they may stain, streak or dull the door surface.

Interior

Cleaning is easy because little heat is generated to the interior surfaces; therefore, there is no baking and setting of spills
or spattering. To clean the interior surfaces, wipe with a soft cloth and warm water. DO NOT USE ABRASIVE OR HARSH
CLEANERS OR SCOURING PADS. For heavier soil, use baking soda or a mild soap; rinse thoroughly with hot water.
NEVER SPRAY OVEN CLEANERS DIRECTLY ONTO ANY PART OF THE OVEN.

Glass Surfaces

Be careful with the edge of the oven door as it is glass and could chip or break. Wipe the window on both sides with a
damp cloth to remove any spills or spatters.

Stainless Steel Parts

The exterior should be wiped often with a soft damp cloth and polished with a soft dry cloth to maintain its beauty.
There are also a variety of products designed especially for cleaning and shining the stainless exterior of the oven. We
recommend that the cleaner be applied to a soft cloth and then carefully used on the stainless exterior rather than
sprayed directly on to it. Follow package directions carefully.

Control Panel

Care should be taken in cleaning the touch control panel. If the control panel becomes soiled, open the oven door
before cleaning. Wipe the panel with a cloth dampened slightly with water only. Dry with a soft cloth. Do not scrub or use
any sort of chemical cleaners. Close door and touch STOP/Clear.

Odor Removal

Occasionally, a cooking odor may remain in the oven. To remove, combine 1 cup water, grated peel and juice of one
lemon and several whole cloves in a 2-cup glass measuring cup. Boil for several minutes using 100% power. Allow to set
in the microwave until cool. Wipe interior with a soft cloth.

Turntable/Turntable Support

The turntable and turntable support can be removed for easy cleaning. Wash them in mild, sudsy water; for stubborn
stains use a mild cleanser and non-abrasive scouring sponge. They are also dishwasher-proof. Use upper rack of
dishwasher. The turntable motor shaft is not sealed, so excess water or spills should be wiped up immediately.

Waveguide Cover

The waveguide cover is located on the right side wall of the oven cavity. It is made from mica so requires special care.
Keep the waveguide cover clean to assure good oven performance. Carefully wipe with a damp cloth any food spatters
from the surface of the cover immediately after they occur. Built-up splashes may overheat and cause smoke or possibly
catch fire. DO NOT REMOVE THE WAVEGUIDE COVER.

Cleaning and Maintenance

Pr

oduct Car

e