Echo PAS Articulating Hedge Clipper Attachment 99944200590 - Manual (Page 14)

14
BLADE ADJUSTMENT
Level 2.
Tools required: (2) 10 mm wrenches
Parts required: None
IMPORTANT
Blades should only be removed and reinstalled by an Authorized
ECHO Servicing Dealer, otherwise premature wear or internal
damage may occur.
1. Tighten blade bolts until snug, then loosen blade bolts 1/2 turn.
2. Hold blade bolts from turning using 10 mm wrench, and tighten
blade lock nuts with other 10 mm wrench.
NOTE
Locking ability of Hedge Clipper blade lock nuts will diminish each
time they are removed. Replace if turning resistance is not felt when
installing locknuts.
S
TORAGE
IMPORTANT
Always store and transport hedge clippers in a stable, horizontal
position. Support gear case and cutting blades to prevent
excessive flexing which may cause damage to the cutting
attachment. Always install blade cover when transporting or
storing unit.
1. Clean and lubricate cutting blades and gear case.
2. Sharpen cutting blades as required.
3. Apply a light coating of clean 20W engine oil along entire length of
blades and on blade bolts.
4. Install blade cover onto hedge clipper cutting blades.
5. Store hedge clipper attachment in a dry, dust free place in a
horizontal position, out of the reach of children.