KITCHENAID 30 Inch Built-in Microwave Oven Installation Instructions - Manual (Page 3)

3
Cabinet Dimensions
27" (68.6 cm) and 30" (76.2 cm) Microwave Ovens
27" (68.6 cm) Models
A. 27" (68.6 cm) min. cabinet
width
B. 18 5 ⁄
8
" (47.3 cm) from bottom of
cutout to bottom of upper
cabinet door
C. 40" (101.6 cm) bottom of
cutout to floor (recommended)
D. 25¹
⁄2
" (64.8 cm) cutout width
E. 1¹⁄
2
" (3.8 cm) min. bottom of
cutout to top of cabinet door
F. 17 5 ⁄
8
" (44.7 cm) recommended
cutout height (will fit cutout
height from 17³⁄
8
" [44.1 cm] to
17³⁄
4
" [45.1 cm])
G. 21 7 ⁄
8
" (55.5 cm) min. cutout
depth
30" (76.2 cm) Models
A. 30" (76.2 cm) min. cabinet
width
B. 18 5 ⁄
8
" (47.3 cm) from bottom of
cutout to bottom of upper
cabinet door
C. 40" (101.6 cm) bottom of
cutout to floor (recommended)
D. 28¹⁄
2
" (72.4 cm) cutout width
E. 1¹⁄
2
" (3.8 cm) min. bottom of
cutout to top of cabinet door
F. 17 5 ⁄
8
" (44.7 cm) recommended
cutout height (will fit cutout
height from 17³⁄
8
" [44.1 cm] to
17³⁄
4
" [45.1 cm])
G. 21 7 ⁄
8
" (55.5 cm) min. cutout
depth
Minimum Installation Clearances
For proper installation, the following minimum clearances must
exist above and below the cabinet opening.
Installation Above Single Built-In Oven
A. Upper cabinet
B. Lower single oven
Approved models: KMBP100E and KMBP107E
Electrical Requirements
If codes permit and a separate ground wire is used, it is
recommended that a qualified electrical installer determine that
the ground path and wire gauge are in accordance with local
codes.
Check with a qualified electrical installer if you are not sure the
microwave oven is properly grounded.
This microwave oven must be connected to a grounded metal,
permanent wiring system.
Be sure that the electrical connection and wire size are adequate
and in conformance with the National Electrical Code, ANSI/
NFPA 70-latest edition or CSA Standards C22.1-94, Canadian
Electrical Code, Part 1 and C22.2 No. O-M91-latest edition, and
all local codes and ordinances.
A copy of the above code standards can be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02169-7471
CSA International
8501 East Pleasant Valley Road
Cleveland, OH 44131-5575
Electrical Connection
To properly install your microwave oven, you must determine
the type of electrical connection you will be using and follow
the instructions provided for it here.
■
Microwave oven must be connected to the proper
electrical voltage and frequency as specified on the
model/serial/rating plate. The model/serial/rating plate
is located underneath the control panel, along the
oven vent.
A. Model/serial/rating plate
■
The microwave oven rated 240 volt, 20-amp, has 4 wires
(L1, L2, N and G) in the flex conduit and should be
connected to a 20-amp maximum rated circuit, overcurrent
protected on both the L1 and L2 circuits.
■
A time-delay fuse or circuit breaker is recommended.
■
Flexible cable from the microwave oven should be
connected directly to the junction box.
■
Do not cut the conduit. The length of conduit provided is
for serviceability of the microwave oven.
A
B
C
D
E
F G
1"
(2.5 cm)
1"
(2.5 cm)
from top
of oven
A
B
For a permanently connected microwave oven:
The microwave oven must be connected to a grounded,
metallic, permanent wiring system, or an equipment
grounding conductor should be run with the circuit
conductors and connected to the equipment grounding
terminal or lead on the microwave oven.
GROUNDING INSTRUCTIONS
SAVE THESE INSTRUCTIONS
A