GE Profile 2.2 cu. ft. Built-In Microwave Installation Sheet - Manual (Page 4)

Installation Instructions
Printed in China
8 INSTALL THE TRIM FRAME
Using a small flat-head screwdriver, remove the 4
screw covers that are installed in the trim frame.
Place the trim frame over the microwave oven.
Open the microwave oven door. Secure the trim frame
using four flat-tipped screws (two on the inside top and
two on the inside bottom).
Insert the screw covers back into the holes and push
firmly.
9 REPLACE ANY LOOSE ITEMS
Your trim kit is now fully installed. Replace any loose
items that were removed from the inside of the
microwave oven. Save or discard the extra screws. Do
not place them in the microwave oven.
Keep these installation instructions for future reference.
Replace house fuse or close circuit breaker to restore
power at the service panel.
7 SECURE RAILS TO CABINET
Ensure the Base Pan and Bottom Bracket front
flanges are tight against the cabinet, and that the
screws holes are aligned. Drive 4 short screws
through the Base Pan and Rails into the cabinet.
Short Screws
49-40782 07-17 GEA
5 INSTALL THE MICROWAVE OVEN
Plug the power cord into the wall receptacle. Slide
the microwave oven assembly gently into the cabinet,
using care not to pinch the power cord. Be sure
to keep the assembly centered as it slides back to
where the tongue of the rails goes through the slots
on Base Pan. The rails should be tight against the
cabinet.
6 CHECK LEVELING
Check the leveling by placing a level at the front
and sides of the microwave. It may be necessary
to add wood shims under the base pan to level the
microwave front-to-back and side-to-side.
Rails
Lower Brackets
4
Flat-tipped screws
Flat-tipped screws
Screw
covers
Screw
covers