Electrolux EOU 5330 - Manual (Page 33)

33
PREPARING CABINET FOR FITTING OF
OVEN
·
Make sure the space between the cabinets is the
correct size for the appliance to be fitted (Ref.
Fig. 5 & 6).
·
The plinth board spanning the space into which
the appliance is to be installed should be
removed.
·
If the size is between adjacent cabinets is 605-
610mm, then the cabinets should be modified so
that the recommended dimension of at least 600-
605mm is maintained.
·
The adjacent cabinets must be stable and level
by firmly securing it to the wall or floor. If
necessary, make arrangements to ensure the
shelf upon which the oven will rest is level.
·
The adjacent cabinets must be stable and firmly
secured to the wall or floor. If necessary, make
arrangements to ensure the work surface below
which the oven will rest is level.
·
Drill two pilot screw holes into the sides of the
adjacent cabinets, in the positions indicated by
Fig. 5 .
·
Fit the appliance mounting brackets using the
two holes indicated in Fig. 7 to the adjacent
cabinets ( Ref. Fig. 5 & 6).
INSTALLATION INSTRUCTIONS
Fig. 5
Fig. 6
Fig. 7