Emerson Radio SB110A - Manual (Page 13)

12
CD OPERATION (CONTINUED)
You cannot program a disc during
playback. If the disc is playing, press the
S
TOP (■)/POWER OFF button ❶ to first
stop playback and then follow the
programming steps as follows.
Press the
PROG button ❷ ; the track number and
PROG indicator will blink in the CD display.
1
2
1
Select the first track to be played back
using the
SKIP/SEARCH ❶ or
❷ button , then press the PROG button
❸ again. Repeat this step to program
additional tracks up to a maximum of
20 tracks.
2
3
1
2
TO PROGRAM THE MEMORY (UP TO 20 TRACKS)
Press the PLAY/PAUSE ( )
/POWER ON button ❶ to begin
Programmed playback and adjust the
VOLUME control ❷ and DBBS switch
❸
as desired.
2
3
1
3
To skip forward or backward through
the programs, press the SKIP/
SEARCH
❶ or ❷ button.
When the disc is through playing, it will
stop.
2
1
4
NOTES:
•
Press the STOP (■)/POWER OFF button to stop the disc before it is finished.
• As each program is played, the track number is shown in the display.
• To clear the memorized program: press the STOP (■)/POWER OFF button
again while in the stop mode, wait approximately 60 seconds and the unit will
turn off or open the CD compartment.
• Programming is the ability to preselect the order in which a series of tracks
will be played.
• Each track may be stored in the program memory as many times as desired
(up to 20 tracks).