Electrolux 50750 VI - Manual (Page 30)

Installation and Connection Instructions
30
INSTALLATION AND CONNECTION
INSTRUCTIONS
Installing the Dishwasher
• The dishwasher must be installed on a firm floor and adjusted to
ensure that it is stable and level.
• To compensate for unevenness in the
floor and to match the height of the
appliance to that of surrounding units
extend the threaded feet by unscrew-
ing. Depending on the design of the
threaded feet use either
– an open-end spanner
or
– a screwdriver.
• For built-in, integrated and fully integrated dishwashers, the rear feet
should be adjusted from the front of the appliance using a screwdriver.
• The drain hose, inlet hose and mains cable must not be kinked or
crushed when the dishwasher is in position.
• In addition, the dishwasher must be firmly screwed to the work sur-
face or to the neighbouring units. This is essential to ensure the dish-
washer does not tip.