beautypg.com

Important, Caution, Warning – Earthquake Sound ROTOTILLERS User Manual

Page 14

background image

OPERATING INSTRUCTIONS ANd PARTS ExPlOSIONS

Front Tine Models

Page 14

800-45-6007

dO NOT OPERATE TIllER BEFORE REAdING
ThE ENGINE mANUAl PROvIdEd IN ThE PARTS
PACkET.

CAUTION

!

TEmPERATURE OF mUFFlER ANd NEAR BY AREAS
mAY ExCEEd 150° F. AvOId ThESE AREAS.

WARNING

!

ENGINE mAINTENANCE

Refer to the engine manual included in your parts packet for
information on engine maintenance. Your engine manual provides
detailed information and a maintenance schedule for performing the
following tasks:
1. Check oil level before each use or after every 8 hours of

operation.

2. Change oil after first 5-8 hours of operation. Change oil while engine

is warm. Refill with new oil of recommended grade.

4. Check spark plug yearly or every 100 hours of operation.
5. Service air cleaner.
6. Keep engine and parts clean.
7. Check engine and equipment often for loose nuts and bolts, keep

these items tightened.

ChECk OR FIll ENGINE CRANkCASE

1. Add oil according to engine manual.

do not overfill. Use a clean,

high quality detergent oil. Container must be marked A.P.I. Service
SF - SJ. Use no special additives with recommended oils.

do not

mix oil with gasoline. Oil level must be full. Check the oil level
by removing oil fill plug. Oil level should be up to the bottom of the
fill plug opening on most engines.

2. Always check oil level before starting engine. Refer to engine

manual for capacity and type of oil to use.

ClEAN TINE AxlE ShAFT

1. Turn off engine. Engine must be cool.
2. Remove spark plug wire and secure from spark plug.
3. Remove all vegetation, string, wire, and other material that may

have accumulated on the axle between the inside set of tines and
the seal on the transmission housing.

4. Replace spark plug wire.

lUBRICATION

Proper lubrication of moving mechanical parts is critical for proper
care and maintenance. Oil the moving parts shown at 10 hour intervals
using a 30 weight oil.

ImPORTANT

ENGINE IS ShIPPEd FROm FACTORY WIThOUT OIl.
YOU mUST Add ENGINE OIl BEFORE STARTING
ENGINE.
ENGINE CAN OvERhEAT ANd BECOmE dAmAGEd
IF dEBRIS BlOCkS ThE COOlING SYSTEm OR
ROTATING SCREEN.
NEvER RUN ENGINE WIThOUT COmPlETE AIR
ClEANER INSTAllEd ON ENGINE.