Emerson Radio iP500 - Manual (Page 35)

34
Stereo Headphone Jack
This system includes a 3.5mm mini PHONES (stereo headphone) jack on the
back panel so that you can listen privately without disturbing others. When the
headphone (not included) is connected to the PHONES jack of this system the
internal speakers are automatically shut ‘Off’.
IMPORTANT! Before you put on your headphones please reduce the Volume
control of this system to a low level. Then put your headphones on and gradually
increase the volume to a comfortable listening level. Remember that digital
music files can contain both very soft and very loud passages. You should
adjust the Volume control to a comfortable level while listening to a louder
passage so that you will not experience any discomfort caused by any sudden
increase in volume level.
The headphones must be disconnected from the PHONES jack in order to listen
to the internal speakers again.
4.) You should hear the sound from your external source through the speakers of
this system.
NOTE: If you connected the Line Out jack of your external source then you
only need to adjust the Volume control of this system. If you connected
the headphone jack of your external source then you may need to adjust
both the volume control of your external source and the Volume control of
this system to find the most desirable volume setting.
5.) When you are finished listening press the Power button of this system to
turn the power ‘Off’. Don't forget to switch off the power to your external source
as well.
NOTE: It is not necessary to disconnect your external source from the
AUX IN jack of this system.
iP500_042307.p65 23/4/2007, 17:01 34