Art DJ Pre II Phono Preamplifier - Manual (Page 5)

INSTALLATION and OPERATION:
1. Connect the AC adapter to the Power Input on the
DJPRE II and plug the other end into an AC power
outlet. If you are using the unit with a home stereo, see
if your receiver or other component has a "switched"
output, which will power the unit on and off with the rest
of your system.
2. Connect the turntable leads to the Input connectors
on the DJPRE II.
3. If the turntable has a separate ground wire, attach it
to the Ground terminal on the DJPRE II to reduce hum.
4. Connect the RCA or outputs to the appropriate
inputs on your mixer or stereo receiver (Aux input, or an
unused tape input). If the mixer does not have RCA
inputs (on any of the channels) a stereo RCA to dual
mono 1/4” male cable may be needed to connect to the
mixer line inputs.
5. Adjust the gain control so the indicator briefly
indicates clipping (red) during the loudest portions of the
music. If the sound is distorted and the led is red
constantly, turn the gain down.
6. Select the input capacitance that sounds best to
you.
7. Use of the low-cut filter rolls off deep bass to
eliminate turntable rumble and "skipping" in heavy feet
traffic areas